On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
I have an '87 Celica and it takes a good 10 seconds of cranking to start. After being parked only 24 hours, it's the same thing. It won't even give a hint of a kick until about the 8 second mark. Then it'll give a couple of sputters and eventually fire right up. Is this the fuel pressure regulator that's the problem? Is it not keeping the fuel at the rail pressurized properly when sitting? It's just annoying having to sit there cranking for so long to get going. I would think if it was the pump, it would give me problems when running.
View 5 RepliesMy problem is with a 2000 Mountaineer V8. Once a year I have to replace the battery after the first cold snap due to low cranking amps. I can simply hook up a battery charger and it will crank and fire. My second problem is most likely related. When I replace the battery it will kick off like a brand new car with no hesitation. After a few starts it takes 5-15 seconds for the engine to fire while the engine cranks normally, and that's how it operates all year. After having this problem again this year (I've owned it 4 years) I've realized the underlying problem is not the battery. All the connections are good, and it has a good ground. No lights or warnings, and when tested with a handheld scanner there are no error codes.
View 11 RepliesI have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
I have a 2001 F-350 7.3L Powerstroke. 48,000 miles. I've been having trouble with cold starts. So far it has always started but is taking a lot of cranking, but it hasn't gotten too cold yet so I'm worried about when it does. I ohmed out the the glow plugs and am getting close to 0 resistance. The GPR has 12.5 volts on the hot side and when the relay is closed 10.5 on the other side. Is that difference in voltage in the GPR enough to screw up the Glow Plugs heating up? If I plug it in at night it starts right up. I'm worried about when I am at work for 16 hours and don't have a place to plug it in this winter. BTW this is my first winter with the truck.
View 14 RepliesI have a 2002 Camry LE V6 with 189K on it and noticed that it takes several seconds (4 to 5 seconds) of cranking before the car starts. When the car was newer, it used to crank quicker.
Here is what I have done so far:
- Changed all spark plugs @ dealer using iridium type
- Always used Premium Fuel (Petro Canada 91 grade)
- Put in a bottle of injector cleaner (Redline Complete Fuel System Cleaner)
- Throttle Body has been cleaned about 20K ago
- Oil changes are Mobil 1 5W30 year round with Denso Filter
- Battery was replaced last year with an Optima Red Top and was tested a few months back to be in excellent working order.
What I have observed is that when the weather is VERY cold outside (i.e. -20), it seems to crank quicker, but if I keep my car parked in my garage overnight and start it, it takes several seconds. I have never had the car not start on me so that's a good thing.
My '08 2.7 has difficulty starting in the morning. It makes the normal cranking noises but won't fire up immediately. I typically let it try to catch for 5-10 seconds, pause, and try again. Then I wait a minute, try again, and everything starts fine. Then it'll start normally the rest of the day.
Pardon my ignorance, but isn't there some sort of compartment that holds fuel into the engine with a check valve that keeps it from releasing back into the tank? Could it be that this valve is leaking?
Or does it sound like I need a whole new fuel pump? I tried to find schematics, but had no luck. I tired hmaservice.com, but I'm not willing to install the Adobe SVG app (obsolete and security risk) to view the documents.
I have a 2000 Accent with 90k miles. The last week or two, it takes about 5- 6 seconds of cranking to start when the engine is cold. Having had the car since new, I know that it's not normal.
The engine seems to crank strongly, and once started idles and drives well. This occurs once about every 4 starts when engine cold. Warm engine starts normal.
Changed plugs - no difference. Maintenance current per owners manual schedule.
The explorer has been having an issue starting after its warmed up. Starts perfectly fine when its cold. but sometimes when I drive, stop for 1-10 minutes, it takes a long time to get her to start up. Typically 30sec to 1 min of cranking. Doesn't seem to have any idle issues or issues running.
View 2 RepliesThis is my dad's car.... Today it began taking a while to start. It will turn over, just doesn't start. If you crank on it a while it will eventually start then runs perfectly fine. The problem occurs both cold and hot. I tried cycling the key 5 times, each time until you hear the fuel pump shut off then cycle again... it's starts just fine doing that. If you shut it off then try to restart, it'll just sit there and crank until you cycle the key a few times. There's no check engine light or OBD codes.
The fuel pump only runs for a second or two when you flip on the key, which tells me it's not having a problem coming up to pressure... and I'd imagine if I had a fuel pressure issue, it wouldn't be running smoothly and I'd have some hesitation, right?
New post for a better problem. It was a hot day today in vegas, but my santa fe was running at normal temp (I double checked with my analyzer), running great. When I got home I turned the key off and took it out of the ignition, all the electrics went out (lights, gauges, etc.) yet the car was still running. It took about 5 seconds or so for it to wind down and stop.
2001 Santa Fe, 2.7ltr, 120,000 mi., 2 wheel drive, great shape, no codes.
Wifes Escape with the 3.0 has been progressively getting harder to start. It spins over just fine, but now takes between 3 to 8 seconds to actually fire. In the last six months the alternator, spark plugs, air filter have all been replaced. Engine runs perfectly, never stalls and seems fine in every other way. I've cleaned the throttle body and the IAC is working fine.
Did some troubleshooting and sure enough, we are getting no spark for a few seconds and the engine runs fine when it finally gets spark. Would this be the crank position sensor? Cam position sensor causing this? Not sure what is supposed to happen during the starting sequence in regards to what sensors are in being read by the PCM and then enabling spark.
My wife owns a 2004 hyundai santa fe, and recently i replaced the belt and idle pulley, I've worked on a few cars in my life and understand the basics and some on how to work on a car.But this has me baffled, the other day i decided to take her car to work. She warned me it had a a slow turn over sometimes i told her okay and headed off to work, drove fine to work no start up issue, but then i went to lunch and it had a slow start like she said. Then in the afternoon started just fine for the drive home to work. I stopped at a gas station to put a little fuel in and the car wouldn't start, it would just release a small cloud of smoke from where the the starter was, so i said ah loose starter wire. That however isn't the case, pulled the plastic shield from the bottom off abd the heat shield off the starter just to find nothing was wrong with either instead its the wire above that running from the wiring harness to the motor, how to fix this issue? Ive attached a few photos
View 1 Replies2003 1.8t gti ... Today when I got in my car...it fired up perfectly normal but when I got in it from leaving school it took 5min to fire up. The engine turned over but wouldn't fire all the time as if the spark plugs were bad. So I bought new NGK spark plugs and had the same issue just a little bit ago.
I know the obvious thing would be to change the ignition coils but they're out of stock everywhere so I have to have them shipped. My question is is the ignition coils the problem? They looked a bit worn but nothing serious.
Several weeks ago I made another thread because I was having crankshaft position sensor problems and essentially that was due to a short on the sensors wires which had become exposed. I replaced the sensor and it still did not work until later trying another brand which solved the problem.
I also changed all six spark plugs, wires, and plenum gasket with OEM parts. I was able to get to the back three plugs by following this tutorial with the guidance of a friend who is a mechanic. After getting this done, the car has run way better and smoother.
However, today it has been raining heavily and I needed to run an errand so I went to my car and turned the key but nothing happened. All the dash lights turned on and appeared normal. My radio works, lights work, etc; but I can not get the car to crank at all. I hear the fuel pump turn on and everything else sounds normal, but still no crank. There are no sounds from the starter at all, it is silent when I try to get the car to turn over.
I took a look at the car and the coil pack seems dry, the plug wires are secure, plus we had put di-electric grease on all those connections. The negative terminal on the battery has a solid connection. I even tried jumping the car to see if maybe it was due to the battery, but again nothing happened.
This has only happened once before when it was raining, before I had changed the plugs and wires, but I was able to get it to crank over after about 4 minutes of waiting and contemplating getting a tow. I took a look at all the fuses and they appear to be intact.
I don't drive the truck much anymore but over time my MPG has gone to total crap...about 10mpg around town...and that's baby-ing it.
Now it suddenly takes many cranks to finally start on a first start. (cold or warm days)....
Need better understanding of the wiring and turn signal selector than I do in my 07 6.0 HD. At first the issue started with the right front and right mirror blinking fast indicating a burnt out rear right turn signal. However after a few seconds the right rear will start working and the speed would be normal. I noticed it worse on very wet days making me think the rear tail light was letting in water and messing with the bulb. But it turns out it does it on nice days too.
These days it has evolved into the turn signal sometimes taking a few seconds before any of the right side actually starts to flash, also sometimes the indicator does not automatically deactivate after a right turn.
Giving the bottom of the steering column a calibrated tap usually always fixes the issue until the next turn.
Assuming its a bad turn signal selector switch Part number YL3T-13K359-ABJAEA but not knowing the wiring diagram I dont see how this bad switch would intermittently stop controlling the right rear turn signal. I would guess that it would tell the flasher left or right, not which lefts and which rights.
I have a 2006 F450 6.0 Super Heavy Duty. The Problem that I am having is when I turn the key it wont crank over. In order for it to start I have to hold the key in the crank position (like i am trying to start it) for about 20+ seconds, and then it will start cranking over. After it cranks over it starts just fine no problems. This only occurs when I start the truck up for the first time each day. After the initial start of the day its fine. (FYI I turn the ignition to the on position and just let it set it still takes me turning the key to the crank position and holding it 20+ seconds).
View 5 RepliesMy 2003 F-250 (gas V8) will always start right up when it is cold. However, once it has warmed up, it often will not start. Cranks fine, but not even wanting to start (like someone pulled all the plug wires) and has left me stranded until I wait for 3+ hours for it to cool back down. Doesn't trip the check engine light, but seems to be due to the engine being hot. What this could be?
View 7 RepliesNeed to diagnose my truck issues. On my 2002 F250 V10, when I try to start it, the engine just cranks and cranks and cranks with no fire or even hint if starting. I am not sure if it has no spark or isn't getting any fuel. I just replaced all ten spark plugs and coils less than 500 miles ago. I want to perform the fix myself, but I need to get the problem diagnose the issue first.
View 8 RepliesTruck stalls out and cranks hard for 7-10 seconds before starting if I don't let it warm up adequately before I start driving. Transmission is hesitant to shift. Also, white smoke comes out exhaust if it's cold and I get in the throttle too much or if I hit 70+mph.
View 2 Replies