The passenger side door of my 08 Accent Hatchback got frozen after cold icy rainy night. I forced it open after few try, and found the rubber seal underneath the door was ripped off (ice in it). I put it back in, but after turn the engine on, the airbag light is on.
After some google, I think I damaged or disconnected the sensor in the passenger side door panel. How to fix it?
How to remove the window cranks from the door panels on the 2010 Accent. I have reaad lots about other models and can't find anything on the 2010. I purchased the cranks removal tool but it don't appear to work at all. I drop by my dealer and that was like talking to the wall, they don't know how to remove the handle.
View 6 RepliesI can't figure out how to open the door panel driver side.
View 6 RepliesWhere the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 RepliesI have a 2007 sonata gls with 2.4l engine. The airbag light on instrument panel stays on. A code b1102 has been stored. The code description is low voltage. I've been told its a bad srs module under center console.
View 2 RepliesThe right side of my driver side door handle recently came detached, and I can't get in my vehicle unless I crawl in through the passenger seat.
View 7 RepliesThe other day, I was sitting in the just the right place with the light shining in the passenger window just right to notice a glistening liquid in the bottom crack of the line that runs around the passenger side air bag panel. (Hope I explained it well enough)
I was concerned about a water leak of course, but I have no water traces anywhere else behind the dash or the kick panel. I spread the crack apart far enough to get the edge of a paper towel in the crack to wipe up whatever it was. Low and behold, it is some kind of really slick, silicone type oil.
If the safety air bag should be leaking oil? Is my family in danger? Do safety air bags "degrade" and start decomposing in time? Could that oil be coming from some other source?
Can I pull that front panel off without making the bag explode?
Just bought a 2007 supercab with the 5.4 in nice shape, but have an intermittent brake light on the dash. (No ABS, just the brake light.) Our mech. diagnosed a bad Brake Fluid Level switch. I can get a new sensor. I'd like to try and replace this myself and save a lot of money if it's not too difficult.
I'm looking for some clear step-by-step directions on doing this, and have a couple of questions:
Do I need to disconnect the battery first?
Do I need to empty the brake fluid reservoir? (Looks like the sensor is in the bottom of the reservoir, if I take it out without draining res, will I have a mess?)
When looking up the sensor online, I also saw the plug/connector for sale, should I replace that as well?
On three different occasions in the past month I noticed air bag light on in my 13 supercrew. Code comes up as B0091 drivers door crash sensor. This truck was bought new and only has 13000 miles on it so my gut is telling me it's something to do with the harness that is at the door hinge. I've carefully inspected the wires and do not see any obvious broken wires but that doesn't mean one of the wires isn't breaking on the inside.
View 3 RepliesAs the title states my clutch is almost gone , been teaching too many people how to drive 5speed and the other day when my girl was driving she burned it real hard and now I can totally notice its engaging very late..
My question is : We just put a stage 1 every clutch in the rx7 and it was amazing but they only make a OEM replacement.
I have a 2008 passat and i want to remove the driver door panel. Well I did the search found what I need to do it, but every search result says to pry off the window controls. I was tugging and pulling all this morning and never could get it off.
View 4 RepliesHow to remove the switch panel. My car didn't come with any fog lights and I'd like to remove blank filler without scratching my dash?
View 6 Replies2007 accent GS check engine light will not come on the instrument panel. Showing a 650 code. What is wrong?
I bought the car a year ago. No check engine light? Could someone have dismantled the light?
Alright, I, like alot of people with these trucks have the rust under their fuel doors from what ive seen and heard is the fuel neck filler plastic vibrating and rubbing, wearing throught the paint allowing water and fuel drips in and getting under the paint.
Well i keep touching up my spots but i have to do it twice a year and it just keeps getting worse, so i decided to go a bit further and clean it, touch it up, and protect it. This is a low $ job. Its not perfect but it is definately better than rust and from a couple feet back you can barely notice it, and hopefully this will be the last time i have to touch it up.
[URL] .....
One of the fog lamps on my 2009 Hyundai Accent has blown and I want to replace it, but I am not particularly technical. How to do this? Or any website or video tutorial.
View 3 RepliesThe air bag light came on a few days ago on the wife's 2007 Accent GLS. What would the problem most likely be?
View 1 RepliesMy air bag warning light is on... What it could be to fix it? 2007 Hyundai Accent 5 speed.....
View 12 RepliesI found some threads about changing the license plate light on a 2009 Hyundai Accent and all of them involved removing the plastic trim inside of the hatch. However, I saw a few people mention that they broke a few plastic clips. I want to prevent breaking any clips.
Also, this ( hyundai-forums.com/184-mc-2006-2011-accent/94825-2009-accent-replacement-bulbs.html ) thread says that the replacement lights for the license plate are 168 or 168LL, but other posters say that they replaced them with white lights. What code are they?
Not sure what happen that led to the Airbag light next to the speedo staying on.
Codes retrieved:
B1346 = DAB circuit resistance high
B1481 = DAB module circuit resistance high
B1329 = DFIS to SRSCM communication error
B2502 = Telltale ind light circuit malfunction
B1388 = Driver Seat track position sensor open or short to power
B1378 = DSAB circuit resistance too high
B2500 = Air Bag Warning light circuit fault
B1511 = Driver Belt Buckle switch circuit open or short to power
Where to begin solving for this problem.
I have an 07 accent se and was wondering what could be the cause of my air bag light constantly being on in my dashboard instrument cluster... it turned on like a week ago and has been on constantly ever since..
View 8 RepliesI have a 2007 f150 sport. I am getting a 24 code on the airbag light and I do know that is Sensor output feed/return circuit open. What I do not know is where is this sensor located and what could it mean if I am getting the code...
View 2 Replies