Accent MC (2006-11) :: 2009 - Noise Coming From Power Steering Pulley
Dec 7, 2013
So I purchased a 2009 Accent hatchback about 11 months ago and so far its been great. However, recently (as in the past 2 weeks or so) I have begun noticing a strange cyclic noise developing from the engine compartment accompanied with some minor vibrations. Over time it has grown more prominent. I would rather deal with this before it becomes worse (and more costly) if its a serious issue.
Some info: I recently took a trip to North Carolina (from Florida). I also recently replaced the spark plugs before I left, so they are relatively new. The car has about 37k miles. After popping the hood and taking a look, it seems as though the noise is coming from the power steering pump/pulley area. The noise seems to match the rotations. Either way, here's a video of the noise (pardon the moving in the video, I was mainly recording for sound): [URL] ....
It may sound like normal engine operation, but it did not make that cyclic sound for the first 10 months, so it worries me. Perhaps I'm just paranoid.
View 4 Replies
Advertisement
I have a 2007 Accent GLS with 70,000 km on it. At times, my power steering pulley will lock up and start to slip. All belts have recently been replaced. After about 2000 km after replacement, is when the problem started. The problem is intermittent and the pump itself turns freely after the belt is removed. When it locks up a loud squealing sound can be heard. This happens only when tight turns are made (usually it's to the left). Could it be related to the pressure switch relief or relief valve?
View 11 Replies
My '02 Hyundai accent's power steering pulley makes noise when the car is turned on all the way. That noise doesn't go away until I shut off the car. It is not the same noise as a belt slipping as I have that problem before and had fixed it by tightening the alternator adjuster bolt.
When I spray a little bit of WD-40 on the P/S pulley bolt(bolt and split washer) the noise goes away. However, it comes back the next day, since I am guessing the WD-40 has been dried away. So, should I replace the pulley to fix this issue or is it something else?
Pic of Bolt (Its yellow and black in the pic) ....
View 11 Replies
I have a 2002 Accent 1.6L and when I turn the wheels all the way too the right or all the way to the left the pulley stops spinning. Could this be that the pump is going bad or something else?
View 2 Replies
2010, 5.4L... Noticed a small oil spot under the truck this morning. Took it into the shop after work, we lifted it up, and ran it for 15 min to see where the leak was coming from, and the truck did not leak a drop... until we turned it off. The oil would slowly leak near the power steering pump pulley. But only when the engine was not running ...
View 1 Replies
When to the dealer today. There is a noise coming from the steering rack on my new Sonata 2009 2.4l. I made a short video to show it to the mechanic with the rattle sound coming from the steering rack. He pulled the car on a hoist and confirmed car need a new steering rack.
View 2 Replies
I have a very slight grinding noise coming from the PS pulley area. Its possibly bearing noise although its hard to say. Is there a specific torque requirement. Any good parts...
View 1 Replies
I have a 2006 Camry 2.4l and I'm hearing a loud noise coming from the idler pulley on cold startups when I put it in gear. I don't hear it when it's in park. The noise gets worse if you turn the a/c on. I have replaced the belt, idler pulley and top motor mount. I took the belt off and cranked it when cold and there was no noise even in gear. I can see the idler pulley moving and can confirm that's the noise but what it causing the belt to make it do that? Could I have bought a defective idler pulley?
View 3 Replies
The battery warning light keeps coming on, stays for a bit and goes off.. not an everyday thing..I took it to the dealer and they said alternator is the problem, had it changed today and while driving back from the dealership the light came on again. What could it be?
View 6 Replies
I bought an 09 Accent and love the car, good mileage and actually quiet. I have developed a noise when I turn my steering wheel. It is not there when the car is cold, but after a few moments, when I turn a corner, I hear sort of rubber on rubber sound as I turn the steering wheel.
View 2 Replies
I am driving an accent crdi 2006. Facing some problem with power steering oil leakage.
View 1 Replies
I need to remove the power steering pulley on a 2001 Toyota Celica GTS to replace the pulley shaft's seal. I've got several pullers, so I figure one of them will work. But, I'm concerned that when I pull it out it could damage whatever it messes with inside. Also, I'm going to try doing this with pump on the vehicle.
View 1 Replies
I have a 2009 Accent GLS. The PS pump has become increasingly noisy, especially when the car is first started and when the steering wheel is turned. The noise is coming from the belt and when it does this it looks like the PS pump slows down and the belt is being forced through by the water pump. I bought a new/remanuf pump; however, the PS pressure switch thread diameter is smaller than the hole in the new pump and does not fit.
I took it back and tried another pump and same problem. Looking at a pump on RockAuto, A-1 CARDONE 215473 {#571001E000, 571001G000}, this one shows a plug with a slot in the hole where the switch screws in. I am at a loss with replacing the pump when I cannot seem to find what the car came with.
View 3 Replies
My Santa Fe has a broken power steering pump pulley. Darn thing broke right around the spindle! I can not find a replacement anywhere. I've tried to find a one new, used and at the upull lots (only one Santa Fe in at Pick n Pull dang thing was stripped clean!). The pump is easy to find but this pulley is a ghost!
View 3 Replies
I have a 2009 Accent 4-door sedan.
I was told during an oil change in the spring that I would need a new battery soonish. I haven't bought one yet.
Last week I tried to start my car and it made a machine gun noise and wouldn't start. A friend jumped it and it started fine. I took it to Canadian Tire and a mechanic tested the battery and said it was over charged, 508 I think, should be 500.
Then today it won't start and is making the machine gun noise again. Now the horn and lights are dimming too when I lock it.
What is going on? I checked the posts; they are clean and tight.
View 4 Replies
When I am sitting at a dead standstill and I turn the wheel lock to lock, left or right, I hear a clicking sound. The clicking is louder inside the car, but I can't tell if it's coming from the steering column or the various linkages in the suspension or drive systems.
If I drive in circles, with the wheel at a constant (or changing) angle, there are no clicks, so I don't think this is a CV joint issue.
What could be causing this noise? I really don't want to take off my lowering springs and restore this thing to the original configuration for a warranty repair visit to the dealership.
If I do, you may see a fire sale of H&R 20mm wheel adapters and B&G lowering springs in the near future.
View 3 Replies
I have accent model 2008, the car has EPS (electrical power steering), Two-days ago, i was driving on high way, suddenly the EPS lit is on and the steering is jammed and i cannot turn it left or right.
I succeeded to stop and turn off then on again, the steering came back to the normal status, I called the service center who i am dealing with him, the Engineer advised me either
1)to change the EPS kit or
2)to change into hydraulic system, i.e., installing a new hydraulic system instead of the electrical one.
View 1 Replies
A friend of mine has a 2007 Accent with some scary MDPS issues. Basically it randomly freezes the steering wheel without a warning making it extremely hard to drive. He went to the dealership and since the car is without warranty they'll charge him 1200$ for repair. Is there any recall on these models for this MDPS?
View 7 Replies
My car has been making this chirping noise for a couple weeks now, and I can't figure out what is causing it. It's really bothering me.
The noise is sinked in with the rpms. While in neutral or while I have the clutch in, the noise stops. The higher the rpms I'm running, the faster the sound goes. I opened the hood the other day to see if I could figure it out, but all I found out from that is it sounds like it's coming from under the engine cover.
Engine? Maybe a component near it? Maybe it's just the cold weather constricting parts to a smaller size?
View 19 Replies
So I have had my 2005 Prius for over a year now. I love my car but after 7 months it made a whining noise coming from by the pulley. When I would accelerate the noise would get worse. Engine light came on tested and said loss of power. The car would not go up large hills it was gutless. So I parked it. I recently just replaced the pulley and now the noise is gone. I have been driving it short distances and at about 30 miles per hour the car would sputter and hesitate. I would let off the gas and push down on gas pedal lighter and it would go fine.
View 19 Replies
I have a '94 Ford E150 (6 cyl). A few weeks ago the pwr steering fluid began to leak. I couldn't readily see where it was coming from and thought no big deal I'll wait until it's more pronounced. After a week or so of topping off the fluid, I heard a pop under the hood as the serp. belt broke (sheared off actually). Not sure if it matters but at the time I was all manual power with the steering as all the fluid had leaked out.
That's when I noticed that the power steering pulley was slightly out of alignment with the others. I replaced the belt, limped home and the next day the new belt sheared off like the 1st (in ribbons wrapped around the fan). Never had this happen before but is there any way to adjust positioning of the power steering pump and pulley?Looking on the bright side, I'll definitely have a chance to get to that leak now.
View 2 Replies
