I need to remove the power steering pulley on a 2001 Toyota Celica GTS to replace the pulley shaft's seal. I've got several pullers, so I figure one of them will work. But, I'm concerned that when I pull it out it could damage whatever it messes with inside. Also, I'm going to try doing this with pump on the vehicle.
View 1 RepliesMy Santa Fe has a broken power steering pump pulley. Darn thing broke right around the spindle! I can not find a replacement anywhere. I've tried to find a one new, used and at the upull lots (only one Santa Fe in at Pick n Pull dang thing was stripped clean!). The pump is easy to find but this pulley is a ghost!
View 3 RepliesI have a 2002 Accent 1.6L and when I turn the wheels all the way too the right or all the way to the left the pulley stops spinning. Could this be that the pump is going bad or something else?
View 2 RepliesMy '02 Hyundai accent's power steering pulley makes noise when the car is turned on all the way. That noise doesn't go away until I shut off the car. It is not the same noise as a belt slipping as I have that problem before and had fixed it by tightening the alternator adjuster bolt.
When I spray a little bit of WD-40 on the P/S pulley bolt(bolt and split washer) the noise goes away. However, it comes back the next day, since I am guessing the WD-40 has been dried away. So, should I replace the pulley to fix this issue or is it something else?
Pic of Bolt (Its yellow and black in the pic) ....
I have a 2007 Accent GLS with 70,000 km on it. At times, my power steering pulley will lock up and start to slip. All belts have recently been replaced. After about 2000 km after replacement, is when the problem started. The problem is intermittent and the pump itself turns freely after the belt is removed. When it locks up a loud squealing sound can be heard. This happens only when tight turns are made (usually it's to the left). Could it be related to the pressure switch relief or relief valve?
View 11 RepliesSo I purchased a 2009 Accent hatchback about 11 months ago and so far its been great. However, recently (as in the past 2 weeks or so) I have begun noticing a strange cyclic noise developing from the engine compartment accompanied with some minor vibrations. Over time it has grown more prominent. I would rather deal with this before it becomes worse (and more costly) if its a serious issue.
Some info: I recently took a trip to North Carolina (from Florida). I also recently replaced the spark plugs before I left, so they are relatively new. The car has about 37k miles. After popping the hood and taking a look, it seems as though the noise is coming from the power steering pump/pulley area. The noise seems to match the rotations. Either way, here's a video of the noise (pardon the moving in the video, I was mainly recording for sound): [URL] ....
It may sound like normal engine operation, but it did not make that cyclic sound for the first 10 months, so it worries me. Perhaps I'm just paranoid.
I have a '94 Ford E150 (6 cyl). A few weeks ago the pwr steering fluid began to leak. I couldn't readily see where it was coming from and thought no big deal I'll wait until it's more pronounced. After a week or so of topping off the fluid, I heard a pop under the hood as the serp. belt broke (sheared off actually). Not sure if it matters but at the time I was all manual power with the steering as all the fluid had leaked out.
That's when I noticed that the power steering pulley was slightly out of alignment with the others. I replaced the belt, limped home and the next day the new belt sheared off like the 1st (in ribbons wrapped around the fan). Never had this happen before but is there any way to adjust positioning of the power steering pump and pulley?Looking on the bright side, I'll definitely have a chance to get to that leak now.
2010, 5.4L... Noticed a small oil spot under the truck this morning. Took it into the shop after work, we lifted it up, and ran it for 15 min to see where the leak was coming from, and the truck did not leak a drop... until we turned it off. The oil would slowly leak near the power steering pump pulley. But only when the engine was not running ...
View 1 RepliesI purchased a new 2000 mazda b4000 2 weeks ago and the belt was squeaking and I knew I had to change the water pump so I replaced it and the squeaking didn't went away... I thought maybe my idler pulley bearing was worn out cause I could see it wobble back and fourth when the engine was running... Replaced it, still squeaking! Change my belt still squeaking! look further turns out my power steering pulley wobbles slightly. I'm thinking about trying a gator back belt and see if the squeaking goes away. Could it be dangerous to run the truck as it with a slight misalignment in the power steering pulley? or it'll be a must replacement asap?
View 3 RepliesHow to remove a crankshaft pulley like this one? It doesn't have any holes for bolts, to hold some soft of breaker bar in place.
Pulley.JPG ....
Preparing for a timing belt replacement on a 2007 elantra. well aware of how to remove the crank pulley and do the job. My question is this : once you have the nut off, does the crank pulley come off by hand or is a puller required? came off nicely wiggling it by hand on any accent i've done, but never done this particular job with the elantra.
View 4 RepliesHow to remove the water pump pulley on a 2003 W8? I removed the 4 bolts but I don't want to go crazy and end up ruining it.
View 1 RepliesI'm trying to remove the AC belt off a '96 Geo Prizm. I've loosened the idler pulley adjusting bolt, per my Chilton's manual, but it doesn't loosen the belt. It's as if the pulley is stuck in the bracket. Even if I completely removed the adjusting bolt the pulley wouldn't budge. How can I unstick this thing without damaging the pulley?
View 6 RepliesI have a 95 Toyota Celica GT which started making a noise today. It does not seem to increase when the engine is revved. The crankshaft pulley seems to have a slight wobble, belt feels tight, does not appear worn. Does not matter if AC is on or off. No performance issues. I'm thinking harmonic balancer replacement.
View 1 Replieswhile out of town the big belt that runs the alternater and ac broke and took out the power steering belt. I replaced the big belt but do not know how to do the power steering one. I can hardly see the back sprocket.
View 6 RepliesI have a '92 Celica GT which runs perfect except for the Overheating problem, the Power Steering problem isn't a big deal for me, Before I owned a '88 Chevy Beretta GT and after that a 94' Pontiac Grand AM SE. They were both pretty crappy.
But I need to figure out why it's overheating like this, Me and my stepdad did a raidator flush on it and it didn't work at all, The fan works fine, but I will be driving it and will have to pull over quite often to let it cool down and put water in it, I've stopped using coolant because I'm wasting too much money on it, and it does the same as the water, I know for a fact it isn't leaking, it acts like it's burning it up or something. I'm not even speeding in it or anything, what's causing the overheating.
I thought it was the radiator but I was told it wasn't, then I noticed the radiator cap was spurting out water and took it to the auto parts store to get it replaced and it didn't work, They told me somebody before I owned it switched the radiator from a 91 Camry? or something like that. That is the cap he replaced it with anyways because the cap for a '92 Celica didn't fit, it was too big. But the car ran perfect when I first got it around December, no problems at all, It just started overheating like this about a month ago.
I have a 94 Celica 2.2. I'm having issues with power steering fluid leaking from reservoir cap. I replaced the cap due to the old ones seal had dry rotted and dip stick was broke off, also replaced the 2 small short hoses and new clamps. The return hose is working right and the high pressure hose seems to be working right. None of the hoses are leaking but pressure is building up and pushing fluid out the reservoir cap. What else could be the problem to cause this??
View 14 RepliesI have a 2002 Celica GT and the cooling loop on the power steering that runs out in front of the radiator (or AC condenser) is cracked and leaking. I need to replace it, I have a few questions:
- Where to get a replacement, likely Toyota?
- Find out how much work it is to replace myself?
- Does the system auto bleed any air or will I have to bleed it?
I am a Honda/Acura nerd. Decided to buy my friends 02 Celica that had piston slap from the famous oil consumption issue i learned about. Did a bunch of research and swapped in a Corolla motor. Everything seemed to go as normal, its in and running just fine. Only problem is now the power steering pump is making a very loud whining noise like its low on fluid.
Now first i must say the car ran, drove and turned just fine before the swap. No noises or issues aside from the piston slap. On the 1zzfe engine there is 2 bolts to remove the power steering pump and move it out of the way, easy enough.
My question is how did the power steering pump manage to get damaged? I've inspected under the car a bunch of times, inspected the top of the power steering pump, inspected everything i could looking for a problem. I just don't see any...no smashed hardlines, no leaks, has plenty of fluid, sensor is firmly plugged in. I notice when it is making the whining sound, the hardline that connects to the top of the pump is vibrating, which is what is making the sound i guess...if i crank the wheel all the way to the right or left it doesn't make the noise at all...
How to remove the sunroof in my 86 GTS?
View 1 RepliesI am trying to remove the engine cover on the passenger side of the engine bay so that I can access the power steering fluid reservoir. What is the procedure for removing the plastic clips, rivets or whatever they are and also how do you reinstall them? This is a hair brained design if I ever saw one!
View 14 Replies