I own a 2004 Toyota Camry. Its just under 100,000 miles. A few days ago the ABS and brake lights started flashing on and off at the same time. They stay on for a second and then go off. It doesn't happen every time I drive the car but it is happening more than it's not. The place my husband took it to said they can't diagnose the problem unless the lights stay on. Is it safe to drive the car?
View 3 RepliesI bought a 1996 Toyota Camry this summer. While I was away, my parents would start it every once in a while, and the last time they did the lights would not stop flashing. The hazard lights, glove box, clock are all flashing. I have the battery disconnected until I can figure it out.
View 1 RepliesI have a 2007 Toyota Camry with electrical problems that started showing up recently. One day the check battery light turned on and about 15 minutes later the AC would lose power intermittently. After parking the vehicle that day I tried to start up and only heard a rapid clicking sound. I exchanged the battery since it was still under warranty and everything seemed to work fine for one whole day. The next day the battery light turned on again, followed by the ABS warning light, and then the airbag warning light. Within about 5 minutes the dashboard back light started flickering and other warning lights started lighting up randomly. Within a minute of that the car shutoff and would not start back up again.
View 2 RepliesI just purchased a 2004 toyota camry limited edition about a month ago. During the last week off and on while the air conditioning is on it will quit cooling and the a/c light will flash on and off until I turn it off. Sometimes I can turn it back on and it will stay on, sometimes it will do it again. Sometimes I can get in the car, turn it on, and it just stays on and doesn't flash at all even on long trips. Anytime the a/c is on, the air is perfectly cold. It's only when the light is flashing that it quits cooling. Today is the first day that it did it multiple times on the way home from work.
By the time I got to my drive way though it wasn't going off and flashing but was once again staying on and cooling perfectly. Since I just purchased the car and have car payments on it, I am not rolling in dough. I have read a few posts that it's possibly the compressor but since mine blows so cold when it's on I do not think that is my problem...then again I could be wrong.
2004 with 214000 miles. Brake pedal goes to the floor, red dash lights are flashing, I just added a container of brake fluid and still no pressure at the pedal. I'm guessing master cylinder.
My question is: Even though my brake pedal goes directly to the floor, how am I getting the car to stop at the very end of the push? Do the brakes somehow work as a fail-safe even the the hydrolics are basically toast? I know that's a long shot, but it wouldn't be the first time I've been shocked over systems in this car.
1) Why is my neighbor's late model Tundra chirping and flashing the lights at regular (maybe 20 second) intervals?
2) Why can I hear it a house away but my neighbor (at home) cannot?
3) Can I stop it? If it something like hey idiot, you left it unlocked with the keys in the ignition, maybe I can.
4) If I resort to violent methods to stop it, will I be subject to criminal penalties. or would a jury of my peers find it justifiable truckicide?
I have a 99 Passat; 5-speed V6. My tachometer would go out intermittently and at the same time the oil and brake light would start flashing and the ABS light would come on solid. There would be no noticeable difference in performance. When the tachometer would come back on line the lights would go go. Now the tachometer appears to be down permanently and the dash lights above are in the same state as above. Still no noticable difference in performance. What may be wrong?
View 3 RepliesI took my 2000 passat 1.8t to a couple of places and both say that my abs and brakes are fine even though there is a flashing light that says brake lights failure and abs light. The brake lights do work. Is there a way for me to clear the code?
View 4 RepliesSo my brake light was flashing and my abs light and traction light came on...i got codes for a faulty abs module and G85 steering angle sensor. I replaced the module and I cleared the codes and they cleared except the steering angle sensor and now the traction light is stuck on? Do i have to zero point calibrate with a vagcom?
View 4 RepliesMy alternator went today, driving and the battery came on .. was concerned but was still on my way, abt 5 miles from my house the abs light and brake lights starting flashing and beeping .. and then caput .. the car shuts off .. figured it was the alternator, cuz thats whats logically made sense .. talk to vwvortex and if so how much do these type of jobs cost ??
View 18 RepliesThis is for our '05 Toyota Camry with 125K miles on the ODO, has ABS but no TPMS.
Around a few weeks ago the ABS light started flashing on start-up. Turned engine off and it went away. This has happened 3 times to far. The light stays off otherwise. Before this we had new tires installed and the car aligned and they said the rear was a bit off (had uneven tire wear), not sure if related or not.
I was able to read the code with shorting two pins and I get 33 & 34 which is both the rear wheel sensors. The part that I am suspicious about is both sensors going out together that not make sense. So I am thinking it is the wiring somewhere. Hopefully not the module ...
For now I have cleared the codes and want to see if they return. The sensors are expensive and seems like I have to take the rear bearing off to change them, so not keen on just throwing parts at it. How to approach the troubleshooting?
So I have a 1.8 5spd wagon which flooded out the comfort control module. I got another CCM but I still have a flashing oil pressure light. a flashing brake warning, a solid ABS light and an airbag light. The tach doesn't work and the MFD only occasionally works. Before I replace the ABS module I would like to eliminate anything else that might be in common with all these systems, is there a hidden fuse anywhere or a relay?
I tried unplugging the ABS module and it didn't change anything, do I need to code the CCM it has the same numbers on it but even after replacement the power windows still don't work even though the door locks, mirrors, and dome light on all but the drivers door ( I assume the micro switch is bad)work now, also the car starts.
Had a small brake fluid leak from my right-rear wheel, so I took it into a local place called Wheel Works. They said the right-rear caliper needed to be replaced, so I told them to go ahead.
Two days after I pick up the car, the ABS light and brake warning lights start flashing intermittently. They'd come on at random times, and then turn back off. After about 2 weeks of this, the warning lights are now on all the time.
I've read elsewhere on these forums that the ABS module on our cars can go bad and might need to be rebuilt. But is it possible that the mechanic caused this problem when he was working on the brakes to replace my caliper? Could it be something more minor than the ABS module? I now have reason to believe this mechanic is shady, so I'm hesitant to bring it back there.
I have a stock '13 GTI with halogens and standard (non-LED) tails.
In VCDS, I coded the CECM to enable the brake light flashing under panic braking and also enabled the activation of hazard flashers under panic braking. Coding was accepted, no issues.
However when I did a driveby test yesterday with a friend watching, neither feature activated. I stomped on the brakes as hard as I could; ABS definitely engaged. So I was wondering a couple things:
Is there a minimum speed required before this will engage? I was probably going only about 35 mph when I hit the brakes.
Does this feature (at least the flashing brake light portion) require LED tails or will it work with the regular tails?
Looking on youtube videos of people who have activated this, it appears that they have both the flashing brake lights and flashing hazards activated at the same time so it would seem that's allowed by the CECM, yes?
Found a screen shot of the VCDS screen to show what I did:
I enabled BOTH bit 1 and bit 2. Some of the research I'm doing seems to hint that I should only be selecting one or the other?
April 2009, I bought a 2009 Toyota Venza which I totally love. About 2 weeks into ownership the battery went dead. I had it jump startd and all was well. In the time since I bought it, the battery has gone dead 5 times. Numerous trips to dealer and can't find anything. The final straw was when I was having car washed and the battery went dead. I had to call tow truck to drag me out of car wash an take car to dealer. This time they saidit was a bad battery. Now my dashlights are flashing dim to real bright and my TRAC light comes on so I can't put car into gear.
View 2 RepliesI've seen This Problem discussed about GMC models but not Toyota Avalon. Why does my '97 Avalon ABS & Track Off dash warning lights Continually flash on occasion? Also, on occasion while making a turn, my car just shuts off! So far, it's started right up without stranding me.
View 10 RepliesI have a 2010 toyota camry that needs a parking brake adjustment. the car still stops with the transmission even if the parking brake pedal is pressed down. I changes the pads in the back and it seems to be a little better, but it's not as good as other Camry's I've been in. Where to look as far as the adjustments go? and possibly how if it's not the usual method.
View 4 Repliesso i had my fogs installed a week ago and today i noticed that when i drive over places that kind of vibrates the car? my fogs flashes. but other than that, they work fine. is it something i need to worry about?
View 4 RepliesI am the owner of a 2011 Hyundai Sonata GLS. It has approx 35,700mi to date.
Ive been apart of the forum for quite some time now. Ive been having an issue for a couple of months now with my Traction Control light being stuck on and intermittent flashes of the Brake light (as if parking brake were engaged) and ABS Lights simultaneously.
I'VE ALREADY HAD THE BRAKE SWITCH FAILURE RECALL PERFORMED. When i was having problems shifting and with my cruise control.
This all started this past winter during a bad snow and ice storm we had here in St. Louis, MO. I was on my way to work and the roads were slick with ice and snow. I was traveling no more than 15-20mph on a freeway and as i was approaching a light it suddenly changed to red and i had to slam on my brakes and make a swift right turn in order to avoid hitting anyone in the intersection. Ever since that moment, I've been stuck with these lights on in my dash.
Let me start this by saying I've done a couple of mods to my car. Hids, aftermarket remote start (professionally), aftermarket stereo, amps, new speakers all around, led lights inside, cup holder mod and led tail lights. That's all of my electrical mods.
Ive taken my car to the dealer several times for this problem. They tried hooking my car up to their code machine and they said the car wasn't communicating with machine and it was the first time they've seen something like this before.
They tried pinning the problem on my alarm and stereo. (as they usually do) They said it was a corroded ground. The dealer cleaned that up and said that fixed the problem. In actuality, it didnt. The issue still was there.
Ive had both the alarm and stereo removed to see if this were the cause my issues. NO...the problem still exists.
Here's a pic ....
Disclaimer: When I refer to lights, I mean the back-lit radio controls.
Noticed they're lights flicker when they turn off the car? It doesn't happen all the time and just kinda weird.
I have a 2014.5 SE Sport and the only thing I can think of is I always have my parking lights on (cuz I turned off DRL) but they always turn off when I open my car. Each time I try to record it, it stops doing it. It usually only last for a few seconds but just thought it to be odd.
I have an electrical problem with the rear brake lights on my 03 Camry. The fuse keeps blowing the instant I step on the brake. I replace it and it blows immediately. So now i can't drive it because I have no brake lights. I'm thinking there is a short somewhere, where to start my troubleshooting?
View 4 Replies