Ford F-150 (2004-2008) :: 1998 4x4 -Tail Light Stays On When Truck Turned Off?
May 1, 2015
My sons 98 F150 4x4. First off he had a head light go out and replaced the bulb. Then a day or so later his tail lights would not go out after he turned the truck off. I had him to replace the pressure switch(I think that's what it is called ) anyways, that didn't work. So now he takes out the fuse every time he turns off the truck, just so the lights will go out. But, when he puts the brake fuse back in, the brakes work fine, but his windows will not roll down. I am totally confused with what is going on.
View 1 Replies
Advertisement
My 1999 GMC Sonoma has a occaisonal problem--the tail lights stay lit after the light switch and the ignition are turned off. The brake pedal does not appear to be sticking. The cure has been to remove both light bulbs, wait a few minutes, plug them back in, and all is well. This might happen an average of once a month, seems more common in hot weather.
View 1 Replies
2004 F150 Supercrew
44400 miles
So I turned on my truck today and the needles acted as if they were possesed. The went under the "starting points" and vibrated there for about 5 seconds or so... Very strange. I also have been getting sluggish power from the truck. Mainly between 2000 and 3000 rpms.. Sound like a diesel at times.
View 14 Replies
I guess not ALL of the time, but pretty often when I turn off my truck and remove the key from the ignition, I get the "key is in the ignition" chime, and I'm not allowed to lock my truck.
View 2 Replies
I HAVE A 2005 f-150 LARIET 5.4 lt. I have been having a problem with my battery being drained. My stereo has been staying on once the truck has been turned off. It has also been coming on when the truck is parked all by itself and draining the battery. Sometimes when i am driving in the truck and turn the stereo on it wont come on, ten minutes down the road the stereo will all of a sudden come on. I have tried removing the relay for the stereo, no difference. I have also removed all fuses for the stereo and entertainment system, yet the draining of the battery is still occurring. What the problem could be?
View 6 Replies
The park brake light stays on brake fluid level is good park brake is not on park brake switch is ok will sometimes go out but always comes back on .My son and one of my buddys also have a 2005 and have the same problem....
View 6 Replies
So here is my issue, my parking brake light stays on. Ive checked my parking brake pads, the cables and the switch. They are all servicable and operational yet the light stays on...
View 7 Replies
I have a 2005 F-150 and the tail lights and turn signals stopped working. Only the park light seems to work and it very dim. I replaced the bulbs and that did not fix the problem, so I checked with a volt meter and I'm only getting 6 volts to the socket. Fuses appear to be good.
View 1 Replies
I have a 2004 F150 XLT and the passenger side tail light doesn't work whatsoever. The light does work for hazards, turn signal, or when braking. The passenger front turn signal works, so does the front and the driver sides tail light. Only the 1 tail light doesn't work. I bought a new brake light bulb and it didnt't fix it, so i swapped the drivers and passengers bulbs out, and it still didn't work. I replaced the 10 amp fuse (#36) in the fuse box. What is causing the problem.
View 2 Replies
I have had this ongoing issue with the rear running lights on my 337; the lights just don't turn on all the time. At first I thought the bulbs were burning out but they aren't. I can just knock on the tail lights and the lights come on and stay on. I assume that it's not a short or bad contact or they would flicker.
View 6 Replies
No tail, turn, backup, flasher, license plate - NOTHING. i checked fuses - cleaned both connectors under the truck by drivers door, cleaned connectors by the spare tire (2) one large one and one small round, the cleaned ground lug on top of spare tire bracket, all bulbs are new. cleaned with LPS contact cleaner, they were new and shiny and reinstalled. NOW - turn is very weak and when i push on brake they go off and the front blinkers blink twice as fast? I a aircraft technician and know my way with an ohm meter but totally stumped.
View 8 Replies
I just started to have this problem yesterday. Engine light comes on and stays on. Engine shakes and truck won't go over 50 MPH. Autozone code checker came up with P0171.
Truck has about 95K miles and I had the spark plugs replaced at 75K miles.
Transmission was rebuilt at around that time also.
I only drove it to Autozone and back today to post the code and see what everyone's opinion is as to what's wrong.
Here's what the printout says : P0171 "Fuel Trim Bank One Condition"
View 6 Replies
He has a 98 F150 4x4 and the tail lights are staying on all the time. I had him to replace the pressure switch(I think that's what it is called) but that didn't solve the problem. So now he has been taking the fuse out every time he stops, just so the lights will go off. When he puts the fuse back in, the tail lights stay on all the time, but his widows will not roll down. The windows roll down when the brake fuse is out.
View 2 Replies
I just put a brand new engine in my 2004 f-150 4X4. Truck ran fine for two days. Yesterday I started the truck as usual put it in reverse. As I was backing up it just stopped running no warning nothing just stopped. All electrical still working fine gauges radio etc. When I turn the key I get nothing no starter nothing. The security light continues to flash slowly even when the key is turned on. Basically the best way I can describe it is. The truck is acting like it is in gear when I turn the key. And the odometer reads check gauges.
View 4 Replies
I have a '96 Ranger XLT. Just recently the dome light stays on while the truck is running. I have checked both doors and door frames. For the life of me I do not see a switch. The light does go off eventually after the truck is shut off (without killing the battery). What or where is the switch for this light..
View 14 Replies
E brakes were sticking so I took off wheels, rotors, calipers, and cleaned the E Brake caliper and lubed it. Started driving and E brakes are still sticking? What gives? Could the cable be hung up? Wonder if I should replace the E brake cables.
View 4 Replies
Having issues with the rear tail lights will not shut off when you turn off the car? This all happened at the same time but I'm not sure what it is???
1. The traction control dash light comes on and stays on.
2. The cruise control stopped working.
3. The rear tail lights won't shut off even when the car is off.
View 8 Replies
Have a trusty 05 stx 4.6 4x4 automatic 44,000 orig. miles/owner ext cab pick up. Just lately I thought I picked up at tree branch or something make a noise very similar to pulling a hung up branch or something.. Stopped, looked under truck (everywhere) no dice! Then did some research.. Noise went away when not giving it gas or gliding in nuetral just when light or heavy accelerating! Where do I begin??
View 7 Replies
Ok, so I'm working on a 2004 Hyundai Santa Fe, 93,000 miles. The vehicle runs great! So great that you cant get it to stop running!! The problem is intermittent and generally happens after the vehicle has been running for at least 3 minutes. I turn the key off and she keeps on running (not dieseling, but running at 340-450 rpms!) I have already removed the aftermarket remote start that was installed on the vehicle thinking that was the problem, it was not. Then I went to the ignition switch and unplugged that, also to no avail! I plugged my scan tool in and can communicate with the computer and view pids while the key is on. When I turn the key off, I should loose communication. When everything acting normal and the car actually shuts off with the key, I loose communication with the computer upon turning the key off. When I turn the key off and the veh. keeps running, I do NOT loose communication with the pcm. The only way to shut the car off is to step on the gas pedal. Otherwise it'll run at 400 or so RPM for an hour or so!!
View 8 Replies
This is concerning my little brothers truck. It is a 2008 4.2 liter with around 55,000 miles on it.
He drove it to work today, and called me this afternoon saying that the truck starts then dies a few seconds later, and the battery light illuminates. He and a coworker checked the battery and connections....cleaned off corrosion on terminals, battery reads 12.xx volts without a load on it, it is the original though.
As of right now he is changing the fuel filter which hasn't been done yet. I also know of issues with the fuel pump driver module. I remember checking the one on my 2005 back when I owned it. As I recall it causes a no start condition, but would it cause a start then stop condition like this? He will check this when he is done with the filter.
Anything else that we can check in a parking lot to try and at least get it home?
View 6 Replies
I recently had my alternator and battery replaced due to my truck dying out randomly on me, tested the alternator and failed, replaced battery, and still got the same results, battery gauge seems to drop quickly, what could be going on, I have been told to replace the fusible link that goes from the battery to the alternator....
View 1 Replies
