93" chevy, k 1500 305 engine, stalled, then hard to restart lots of black smoke, fuel, no air? Bad mixture? When it starts it backfires, runs rough black smoke, and stalls again. dist. module ck. o.k. cap and rotor good.
View 3 RepliesI have a 1995 GMC Sanoma, 2.2 Lt, 4 cyl, 5 spd. It has about 130K miles. Each day I drive it back and forth to work (about 30 miles one way). About 6 months ago I noticed that at about 5 miles into my drive to work it would stutter but then catch itself and go on the rest of the way with no problems. On the drive home it would do the same thing at about 8 miles into the drive. This didn't really bother me until one day instead of stuttering it stalled but I could restart it right away while coasting. It had steadily gotten worse to where I had to pull over on the side of the road and restart because it wouldn't restart right away. Nowadays I hardly drive it at all because I'm afraid it will stall and not restart at all. I have replaced the air idle control, fuel pump relay and the positive battery cable. The symptons now are basically the same but different, I can start it (anytime, morning or evening) and it will idle fine for about 5-10 minutes. It will then start to stutter and try to catch itself, the idle will then rev up to about 1500 and then come back down and stutter some more before stalling. After that it will not start back up until maybe 10 minutes after, (it acts like it is not getting any fuel) but once it starts it runs fine, I drove it around for about 20 miles and it ran real strong. The next day it went through this same cycle again.
View 1 RepliesI've got a 2001 Chevy Prizm (160,000 miles) Starts right up-after I drive for awhile and turn the engine off. It won't restart at times - I have to wait anywhere between 5 and 20 minutes till the engine will start again. The engine cranks - so it's not the starter or the battery.
View 4 RepliesI have a 1993 Chevy Silverado, 350, 2WD. It has a 4L60E transmission. I just started having a problem shifting from 1st to 2nd. When accelerating the RPM's go way up and won't shift until I let off the throttle. Then it shifts into all other gears normally.
If I accelerate slowly. it will shift into 2nd at about 16 MPH. It will then shift into all other gears normally. I have replaced the Throttle Position Sensor, flushed the transmission and replaced the filter and fluid. This made know change in performance.
I am now suspecting that it might be the 1-2 shift solenoid. The check engine light is not on and everything else works fine.
I have a 1993 Chevy Silverado rwd automatic 350 5.7. It died on me on the way to work this morning. It slowly lost power and acceleration. The lights and radio all worked. When I tried to restart, it tried to start but then just cranked like it had no fuel or spark.
I had it towed home and checked the following things. I removed the fuel filter, it is clear. I verified that the fuel pump was working by turn the key to the on position while the filter was off. Good stream of fuel. I verified that there was fuel to the TBI. Good spray while cranking. I verified that there was spark by pulling a plug out, connecting to the wire and cranking the engine. Spark seemed weak but there was spark. The front plugs were dry, but the rear plugs, especially #8 was very wet. I verified the timing by pulling the #1 plug, removing the distributor cap and checked the rotor position. I bumped the engine to get the #1 piston to the top of the cylinder and the rotor was point directly at the #1 plug wire. The cap, rotor, plugs and wires are only 1 month old.
I also tried to check the ignition coil by disconnecting the coil wire from coil, and slid the boot back to expose the contact. I held it just of the coil while the engine was cranked, but did not actually see a spark at the coil. I did not hear any arcing. I pulled another plug and checked for spark. Again i had spark. Just seems weak to me. I am on my way to the auto parts store to get a new coil.
I have a 1993 Chevy Camaro z28 5.7 with about 135,000 miles. It made a whining/humming noise recently. It sounded soft at first, added oil the. Noise would go away. One time it got REALLY loud, spooked my girlfriend as well as me, then it stalled out and died. I checked the oil but that was fine so it bothere me even more. So I Let it sit for a few minutes then started with no problem. It happened again recently but i slowed down an it gt really loud again. Let it rest then tried going home. I was going about 75 miles per hour until it didn't want to give gas and started to stall. I pulled over and shut it off for a bit them drove it home while it did that stalling out about twice more.
View 1 RepliesI have a 1993 toyota tercel that has a strange problem. The car starts fine when the engine is cold. If I drive it 15 to 20 minutes and stop and then try to start it again it will either not start or if it does, it makes a putting noise and shakes. Also if this is happening and I turn the steering wheel, the car will stop.
View 5 RepliesMy 2011 Camry XLE 6 cylinders, 50000 miles, stalls in a wet weather when it has being driven over standing water. Last time, about two weeks ago, it was rainy and I was driving with lots of running water around. Suddenly, car stalled and I could not restart it. I kept trying to restart, but all attempts failed and I called for tow truck. It would run for a few seconds with lots of light on the dashboard and stall. I was waiting for an hour and a half, rain stopped an hour after my car stalled and I was able to start the car and drive home. Next morning I started to drive in rain and dashed board lights started to light on. During next two weeks I showed the car to two very experienced mechanics and they could not find any problem.
View 2 RepliesI have a 2000 Nissan Xterra. About a month ago it stalled while I was backing out of a parking spot. When I turned the key, the engine turned over but wouldn't start. A few minutes later it started and I drove it on a long road trip. It was fine until today when it stalled when my husband was going around a corner. He waited a few minutes then it started. Now tonight he started it, drove down the block and it stalled again. This time it won't restart.
View 1 RepliesMy 2010 Elantra stalls while driving, even on the highway, and then won't restart right away. It has been at the dealer for a week now, and they have determined that the ECU is the problem.
View 5 Replies1990 Celica 2.2 liter, 5SFE manual trans car with 239k miles.The car occasionally stalls after it is warm and won't restart. When is is cold she fires right up as it does most of the time when she is warm. To restart he sprays starter fluid in the intake or waits until it cools down. Also as the car gets warm the idle decreases to around 650. Adjusted idle speed to 750 but no effect. The only code is 1-2, low or no RPM, measured the RPM sensor air gap and within spec, measured the sensor resistance and within spec. sensor wiring and connector looked good, measured the temp sensor and within spec, disconnected the EGR vacuum line and no effect. Problem occurs once or twice a week but at the most embarrassing place.
View 4 Replies2000 Sierra 2500 pickup truck. What would cause my truck to stall randomly and not start? Then after waiting a while it will start.
View 4 RepliesMy 2005 Chevy Impala is taking a long time to crank. Now after 10 minutes or so of either idiling or driving, the car stalls out. I am able to restart it. Replaced the battery and no change. Lights are not getting dim in any way so I figure it's not the alternator. Could it be a bad starter?
View 2 Replies2003 Prius starts then stalls (shudders bad) then starts right after with no problem.
View 2 RepliesA week ago, driving home, the tech started to drop quickly to zero then recover, like the ignition was turned off and then back on. I was able to make it home. The car was due a tune up. I replaced the crank position sensor (OEM), replaced sparkplugs (Autolite Iridium), air filter, fuel filter, no luck. I ohmed the coil packs, secondary resistance showed good, replaced the ignition control module (aftermarket). After this, engine would stall after it was at temp, could restart, once put in gear it would stall, but I could go in reverse and drive home backwards.
Reinstalled original OEM ignition control module. Towed to GM Dealership, mechanic said fuel pump was bad, ignition wires needed replaced, one injector ohmed bad. I took car home, replaced fuel pump (OEM), ignition wires (OEM), no luck. Removed plenum, found pcv valve clogged, and hose kinked, replaced both, ohmed all 6 injectors, 5 injectors read 12.3 ohms, 1 injector was 11.6. Replaced all 6 injectors, (Napa), plenum gasket, still same problem.
GM dealership said computer said no data, they though perhaps ignition control module was bad, but I don't think so. I hooked up my Actron shorting plug, reads code 12 which means no faults, no other codes. I noticed EGR valve has a lot of carbon in the hole, thought about changing it, but I'm really not sure where to go now. The car is a 1994 Chevy Lumina with 230,000 miles, spent about $500 the last week doing brakes, and trying to fix this engine. Where to go from here.
2006 Chevy Express 3500 ... Vehicle surges, hesitates, stalls, backfires, and is hard to start after stalling.No codes are thrown, and have had the fuel system checked out without results. 159.000 miles. last mechanic said it was not a spark plug issue. Been an ongoing problem for several months and getting worse all the time.
View 2 Replies96 teg 1.8 non vtech after a while it will lose spark some times it runs for a few days then loses spark but will start up with in 10 min sometimes it just just stalls out and loses spark but restarts with in 10 minutes.
View 1 RepliesMy '96 Dakota SLT 6-cylinder pickup backfired and blew a hole in my muffler ... I've had it in three different shops on six occasions since and the thing still hiccups, backfires, stalls ... most of the electrical switches and sensors have been replaced ... right before it back fires, it feels like it is going to stall, then "POW" ... sometimes it continues to run fine for a little while after that ... then it happens again ... When it stalls it feels like it is running out of gas ... it is almost impossible to restart right away, but if I wait a few minutes, the starts right up ...
View 1 Repliesmy daughter has a 91 volvo 240 with a 4cyl and auto. roughly 100000 miles. it starts and runs fine but after driving it, if it is shut off for less than 30 min, then she tries to start it again, it stalls immediately. she can keep her foot on the gas slightly and drive it the distance of a parking lot, the car will run fine and not stall. i was curious if a tune up would fix this or if there is a smaller fix such as a sensor.
View 1 RepliesTwice now in the past week, my 2001 Jetta has become possessed. While driving along, the radio turns off. Then the warning lights all come on. If I use the turn signal the radio springs back to life and other weird electrical things happen. Eventually the car stalls. When I try to restart it, the warning lights all come on and the dashboard makes a click-click-clicking sound, and that's it. The first time, my mechanic said the alternator wasn't working correctly, but that he revved the engine and it kicked in. He then tested the alternator and battery and said both were ok. Is this an alternator problem? Something else?
View 2 RepliesI have a 86 Ranger with the 2.3L fuel injected 4 cylinder and a 5 speed manual transmission. I can drive it for hours on the highway but if I get caught in stop and go traffic, it stalls and won't restart for about 10 minutes. When trying to restart it acts as if it is fuel starved. Spraying carb cleaner in the throttle body does make it run for a second or two. I was getting a code 18 & 67 before I changed the ignition module, now I just get code 67 or 11. I have done the following:
-Changed both fuel pumps, tank and frame rail pump (did one at a time, no improvement)
-Changed all fuel filters (in line filter, fuel reservoir filter and tank filter)
-Changed ignition module on distributer
-Changed both relays that control fuel pumps
-Cleaned battery terminals and body ground connections.
-New gas tank fill cap
I'm at a loss now as to what to do. I have been checking the codes with my multi-meter. I do not have a OBD1 diagnostic tool.