My 2005 Chevy Impala is taking a long time to crank. Now after 10 minutes or so of either idiling or driving, the car stalls out. I am able to restart it. Replaced the battery and no change. Lights are not getting dim in any way so I figure it's not the alternator. Could it be a bad starter?
View 2 Replies02 Chevy Impala with 177,000 miles has re-starting problems for last 20,000 miles. New Battery, cleaned throttle plate, new fuel pump, check engine light on (emission problem was told to me by mechanic). Whats going on?
When the car runs it runs very well...to get the car started, just wait, sometimes 5 minutes, sometimes longer than an hour. All the time periodically cranking the engine...just does not start. But when it does start, it runs very well.
This problems occurs only after the car has started and is warm. Let it sit for a while then restarting the problem occurs.
96 teg 1.8 non vtech after a while it will lose spark some times it runs for a few days then loses spark but will start up with in 10 min sometimes it just just stalls out and loses spark but restarts with in 10 minutes.
View 1 Repliesmy daughter has a 91 volvo 240 with a 4cyl and auto. roughly 100000 miles. it starts and runs fine but after driving it, if it is shut off for less than 30 min, then she tries to start it again, it stalls immediately. she can keep her foot on the gas slightly and drive it the distance of a parking lot, the car will run fine and not stall. i was curious if a tune up would fix this or if there is a smaller fix such as a sensor.
View 1 RepliesI have a 2010 F150 SCREW with 4.6l 3v 4wd. Up to 100,000 miles nothing more than tires, brakes, and evap purge valve (50,000 miles). Check engine light came on right around 100,000 miles and had no driving problems other than some crappy fuel mileage. Did the following:
Changed evap purge valve, reset cpu by unplugging. CEL came back on after about 200 miles
Took the truck to a shop to get oil change, change plugs, diff fluids, transfer case fluid and get CEL looked at. Shop recommended changing intake gasket as you could see gummy type fluid on passenger side valve cover. When removing the intake found the intake cracked, changed gasket and intake. They reset the light. 200 to 250 miles later the CEL came back on.
Took it back to the same shop, left it with them for the weekend. they think it could be the O2 sensors. I went out and got the shop all 4 O2 sensors and they installed for free (seeing as I spent $2500 with them for all the previous weekends work) 200 to 250 miles CEL came back on
Determined to find time to have another shop look at the problem and trying to get it to a family friend, wasted about a month. At the end of February stopped at a friends house after being there for 20 minutes tried to start truck, it wouldn't fire. It would crank but no fire. Called for a tow and while waiting tried to crank the truck and it fired up, like nothing was wrong. Cancelled the tow truck and drove right to dealership. They determined it was the MAF sensor. Spent the $500 to have them diagnose and change MAF. All things good for about a month and about 3000 miles...
Now in the past 2 weeks it has done the following: I am a construction manager so i am in and out of my truck all day so the engine is never really a cold start except for the mornings when driving to work, it stalled while leaving work on a Friday at low speed. luckily I was able to pull in to a gas station. Tried to restart and it cranked but no fire. after 5 minutes or so tried again, fired up drove home the 35 miles with no problem, truck had power, smooth idle. No CEL.
Same weekend on Sunday, coming home from church at highway speed truck got sluggish, wrench light came on, no response to throttle. Rolled to a stop and then the oil light came on and chime from dash. Turned the key all the way off waited 10 seconds, again crank but no start. Waited 5 minutes and it fired up no problem. Church is only 3 or 4 miles away, no problem going to church, 2 miles into the trip home is when it stalled.
Drove all week, 500 plus miles without a stall or problem
Coming home on Saturday from my kids soccer game again 4 or 5 miles away (no problem going to game) truck stalled at highway speed. Coast to a stop, wrench comes on and then oil light, chimes from dash. Turn key off, wrench and oil light do not come back on. Try to start, again crank but no fire. waited the 5 minutes or so and it fired up fine. (Earlier in the day i got gas, 87 octane, from a one of my regular gas stations from 1/4 tank to full)
Today coming home from church but running an errant the truck stalls after making a left turn about 3 miles from the church at low speed.
All of this without a CEL. What can solve this problem. Clean a sensor? clean throttle body? Gas tank additives? I am due for an oil change and may ask the dealer to look at it but its going to be time consuming as I cant radially repeat the problem and there is no CEL. As I am thinking about the different times it stalled, other than the first time I was probably around 1900 to 2300 rpm.
I've been trying to get her up and running for awhile now in order to sell her. I bought the car from a neighbor who never drove it (only 50k miles on it) and my dad had a great idea to get some new parts for it...I just wanted the car as it was... So we replaced the original carb for a newer carb and my father did all he wanted to do to it (I do know he took off the distributor, did some thing with the clutch, and replaced the fuel line to the distributor).
Well, when all was said and done (after a year and a half), the car is back up and running BUT when it sits idle it stalls. It will only stay running when you keep on the accelerator to rev the engine. As soon as you let up, the RPMs drop and she stalls. He's not sure why it's doing it, and I'm even less sure.
What are some reasons/causes/possible fixes for this?
98 tracker with 5 speed manual transmission has new clutch pressure plate throwout bearing and shit cable. strictly mechanical clutch mechanism drive for about 30 minutes and clutch goes away and unable to shift gears. let it sit overnight will work until about 30 minutes of drive time when everything has a chance to heat up...
View 8 RepliesMy 2000 impala starts when cold, runs for 10 min and dies, i found its losing spark when warm, i changed the coil packs, control module and cam sensor and have had no changes, it dies, and doesn't start, only turns over, i leave it for 30 min er so and it starts , runs for 10 and dies....
View 4 RepliesI have a 2000 Chevy Impala and it seems that every now and then when I try to start the car the security feature activates and I have to wait 10 mins to try to start it again. On some occasions when the 10 mins are up and I try to start it the feature reactivates and I wait another 10 mins. This actually happened on a ferry ride and I held up the offloading of vehicles. My question is, Will a remote starter installation alleviate this issue? If not. What can I do?
View 5 RepliesI've got a 2001 Chevy Prizm (160,000 miles) Starts right up-after I drive for awhile and turn the engine off. It won't restart at times - I have to wait anywhere between 5 and 20 minutes till the engine will start again. The engine cranks - so it's not the starter or the battery.
View 4 RepliesI have a '99 Chevy 2500 diesel truck. After driving it at highway speeds for more than 20 minutes and turning it off, it won't restart. The problem seems to be in the battery cable and is definitely heat-related. In cold weather or after a fairly short drive, all it takes is popping the hood to cool off the engine compartment, and waiting. If the engine and/or the weather is too hot, that can take an hour. Then it starts just fine. I've cleaned the terminals and made sure the connections are tight. Two mechanics have looked at it and were stumped.
View 1 RepliesI own a 2001 chevy impala 3.8 and I recently had a good friend of mine whose going to school as a mechanic install a manifold gasket upper and lower but now I am hearing this loud tick tick tick sound for about 2-3 min every time i start my car in the morning and then the noise goes away and its normal it never made this noise before is it harmful and break my engine or is it okay to just leave it....
View 12 RepliesMy 2001 Chevy Venture stalls after driving it approximately 15 minutes and won't start for about 20-30 minutes, then same problem occurs. I've had the following parts replaced to date, with no success.
AIR FILTER
ENGINE CONTROL SYSTEM
IGNITION MODULE
FUEL PUMP AND WIRING
I have a 1991 Chevy Lumina and I believe this wire is the root of my problems. I
wasn't the one who unplugged it but it seems it was unplugged as an easy way to get around a problem. When unplugged the car runs but the performance is off, It doesn't feel like it has the same power as it does when it's plugged in and it also sounds different when in idle. When the wire is plugged in the car stalls while driving at random intervals between 1 and 10 minutes and needs to be jumped to start it back up. I will attach pictures of the wire and its location within the surrounding area.
I have Jeep Liberty 2002 with 100300 miles. I having starter problem and the starter was replaced with a new one. Still I am having the same problem, the car can only re-start 30 minutes or more after I shut it off. The mechanic stated that he does not know what it is causing the problem.
View 11 RepliesMy 2011 Camry XLE 6 cylinders, 50000 miles, stalls in a wet weather when it has being driven over standing water. Last time, about two weeks ago, it was rainy and I was driving with lots of running water around. Suddenly, car stalled and I could not restart it. I kept trying to restart, but all attempts failed and I called for tow truck. It would run for a few seconds with lots of light on the dashboard and stall. I was waiting for an hour and a half, rain stopped an hour after my car stalled and I was able to start the car and drive home. Next morning I started to drive in rain and dashed board lights started to light on. During next two weeks I showed the car to two very experienced mechanics and they could not find any problem.
View 2 Replies93" chevy, k 1500 305 engine, stalled, then hard to restart lots of black smoke, fuel, no air? Bad mixture? When it starts it backfires, runs rough black smoke, and stalls again. dist. module ck. o.k. cap and rotor good.
View 3 RepliesI have a 2000 Nissan Xterra. About a month ago it stalled while I was backing out of a parking spot. When I turned the key, the engine turned over but wouldn't start. A few minutes later it started and I drove it on a long road trip. It was fine until today when it stalled when my husband was going around a corner. He waited a few minutes then it started. Now tonight he started it, drove down the block and it stalled again. This time it won't restart.
View 1 RepliesMy 2010 Elantra stalls while driving, even on the highway, and then won't restart right away. It has been at the dealer for a week now, and they have determined that the ECU is the problem.
View 5 RepliesI have a 94 Sonoma SLS, V6/auto that has a weird problem of not restarting after I stop for fuel or at the house for a few minutes. The engine will crank normally but acts like it isn't getting fuel. I have had the fuel pump replaced already and I just replaced the fuel pump relay. I additionally replaced the coolant sensor(long shot there) when I replaced the radiator due to a leak.
View 3 RepliesMy 1986 B2000 problems started when the engine would run for a few minutes and not restart. After it sat a while, it would restart.
Through out the process of seeking a fix, I have replaced the fuel pump, coil, distributor cap, rotor, pick-up coil in the distributor, condenser, and spark plug wires and coli wire.
Currently, there is no spark out of the coil wire feeding the distribute.There are 12 volts at the positive and negative side of the coil terminals when the key is in the “run” position.There is about 10 volts to each coil terminal when the engine is cranking over.
I have tried using the old coil and the old pick-up coil in the distributor, but with no luck.