Durango :: 2001 - No Start And No Spark
Feb 1, 2012
I am working on a 2001 durango 4.7 that will not start I guess it was running bad one day on his way home but he made it home. He noticed two vacuum lines looked really cracked so he replaced them still was not any better. He said you could hear a slaping noise on the passanger side front of the motor for about 2 years. I figure that was the slack in the timing chain. Then it sat for a couple days and know it will not even start I scanned it and showed bad cam sensor PO340 code. So I replaced it and decided to pull a plug and coil and stuck the plug in the end of the coil and held the coil so the plug thread was up against a bolt and cranked and have no spark. So I went and picked up a crank sensor and replaced the old one. Still no start and no spark testing it the way I mentioned above. What to try know not very familiar with these 4.7 and dodge for that matter.
View 7 Replies
Advertisement
I have a 2001 Dodge Durango with the 4.7 liter V8. I recently changed the spark plugs and it ran for a few days misfiring periodically. Then overnight after a good day of running it would not start. The engine will rotate but not fire. I changed the individual coils but only to get the same result. I think that I may have the wrong spark plugs but where to go next.
View 6 Replies
Why my '01 Passport will not start? Was driving down the road and it just shut down on me. It cranks but will not fire. Replaced timing belt, fuel pump, and now ECM still not luck. I know it's getting fuel to the rail but no spark!
View 1 Replies
2.4L. Starter cranks but engine doesn't start. Per other forums I have changed the crank sensor and cam sensor, spark plugs. No change. I went back and did Volt meter test on the new sensors: Crank sensor showed 13 volt on red wire, 0 and 5 volt while cranking on blue wire. Cam sensor had 13 volt on red wire and 13 volt on signal wire while cranking. Was expecting alternating 0-5 volt. Could I have a bad ECM?
View 2 Replies
I somehow managed to kill my 04 Santa Fe 3.5 while doing the dreaded spark plug change and looking for pinpointing and rectifying the problem.
A quick rundown of the car... My mom bought her new in late 03, decided to get a BMW X3 a couple of years ago. I bought her with 65k miles. I just recently had the timing belt replaced by a reputable shop at 79k (yes I know I let it go too long.) I just hit 80k and decided it was also time to do the plugs as I had noticed a decrease in performance and gas mileage of late. Other than the recent dip in performance the car has been extremely reliable and has had no previous issues.
I researched as much as I could knowing that the 3.5 isn't the easiest engine to work on. I bought the recommended Champion plugs that came in the car from the factory as well as the oem Hyundai wires. I also replaced the plenum gasket.
I took my time replacing everything but despite my best efforts, I accidentally cracked the plastic on the radiator reaching over to the back bolts on the plenum. Other than that mishap, the only other issues was the #5 plug sticking which finally came loose after some begging and pleading to the car Gods. Unfortunately, my begging and pleading was enough for them to allow the car to start.
After reading a thread on here, I believe the problem is that I removed the TPS sensor to get to the bolts on the EGR valve, I know now that this was a big mistake. I checked and double checked every connector and can not find one that was missed or disconnected. The car would try to start but would not crank over. I was unable to get any OBD2 codes from my code scanner.
I decided to try a TB from a junkyard and swap it on to see if that was the issue. After swapping it on, the car started and ran like crap for about 15 seconds and stalled out. I was however able to pull some codes in this short time.
The codes I received are:
P0102: Mass Airflow Circuit Low Input.
P110 & P1172: ETS Improper Motor Current.
P1192: ETS Limp home - Target Follow Malfunction.
P2127: Throttle Pedal Position Sensor "E" Circuit. Accelerator Position Sensor 2 Voltage Too Low.
I'm not sure if these codes are left over from before I swapped out the TB or not. I reset the codes after I wrote them down and researched them to see if they reappeared but the car will not start again so I can't get the codes to reappear.
View 7 Replies
I have a no start no spark situation i am having trouble diagnosing
Truck started and then died it has fuel pressure but no spark I know that there is a theft light that is flashing (slowly) when the key is off. Could this bee the problem?
View 14 Replies
I am new here just bought a santa fe 2002 2.4 model and its playing up it will start run for a few mins then die and wont start again for a while. the crank sensor has been renewed as has the cam position sensor the fuel pump makes the normal noise so fuel is getting threw the only other symptom is when it cuts out and wont start i check both ignition coils and neither are sparking yet there is power to both, all fuses are fine .
View 21 Replies
I have a 2001 Dodge Durang. 105k miles.
Brake pedal is real soft goes pretty far down (close to floor) before brakes kick in.
Check front disc pads and rear shoe pads, both look good. Fluid level is good. Bleed brake lines.
Pump brakes up when car is off, pedal is real firm till I turn car on an push on brake pedal right to the floor.
View 4 Replies
Early this morning, after a night of freezing rain, i noticed the rear wipers running even though the car/ignition/wiper switch were all off. truck had not been started in over 24 hours. was unable to stop motor from running except only by disconnecting battery lead terminal. on trip to local mechanic hours later, motor would not stop, except when I turned-on front wipers -- then the rear motor would immediately stop at whatever position wiper blade was in. motor would not park blade. only tripping the front (separate) wiper switch would interrupt power to rear wiper motor. At mechanic, problem would not reappear. learned later that similarly, the front wipers would not quit two weeks earlier. at that time, the front wipers eventually stopped some time after ignition was killed and vehicle sat idle with all switches off. Common thread is problem appears during rain storms and does not manifest during dry times.
View 3 Replies
A few weeks ago while driving to work, my gas light came on and then started randomly blinking and dinging. At the same time, my headlights and dash illumination lights started blinking.
I filled my gas tank and the gas light turned off, but the headlight blinking still remains. When they blink, I can hear a relay? clicking to the left of the steering column.
It seems to take about ten minutes of driving for the problem to develop and then the lights blink every few seconds.
View 14 Replies
I have a 2002 Dodge Durango with puzzling brake issues. I noticed while driving that the car suddenly started to pull to the left. When i got to my destination the front drivers side tire started to smoke and unleash un ungodly smell. I let it cool, removed the tire and checked the brakes. Everything seemed to be fine. I also checked the calipers, also fine. I put the tire back on and it drove fine for a month or so.
The next time i was driving and the same thing happened. now it was the passengers side. Again i checked everything and it was fine. It was time for new brakes so I replaced them. Fine for another month or so. It is now happening on the drivers side again. I appologize if this is posted twice now, but i couldn't find it or see any responses.
View 3 Replies
I have a 2005 Durango and it just dies on me and when I shut it off it won't start. It turns over but nothing else, Just started today. Starter? Crank sensor?
View 1 Replies
I just purchased a 2001 Dodge Durango 4wd with 140,xxx miles on it. My issue is that whenever I accelerate it hesistates and if I am going at a high speed like on the interstate or expressway it sometimes slows down (drastically) if I'm going uphill. What can be causing this?
View 6 Replies
I have a 2001 Durango. My one year old battery suddenly began to lose its charge last month if the car sat for two or more days. A local repair shop determined the alternator was okay, but the battery was bad. The parts store agreed and replaced the battery under warranty.
A week later the new battery also went dead after the car had been parked for two days. I then took it to a Dodge dealership that kept it for over a week, but couldn’t find anything wrong. Even after being parked over the weekend, it started right up for them.
After getting it back home I drove it for three days. I parked it for two days, and the third morning the battery was completely dead. After charging with a trickle charger for a couple of hours the car started fine.
I bought the car new and have kept up on all the maintenance. It’s parked in my driveway the same way for over seven years with the doors locked. What’s going on?
View 5 Replies
My 2001 Dodge Durango has an intermittent clunking that seems to correlate to the wheels rotating and happens: at low speeds (0-5 mph)... however, it has gotten worse if I drive continuously for an hour and then stop. It will happen between 0 and 30mph and be much louder.
When the clunking happens, the steering wheel also rotates to to the right and the car will shake a little.
If I had to guess, the clunking is coming from the front left but really could be anywhere.
I have taken it to FireStone multiple times, they have test driven it all over... it never seems to happen when they have it.
View 3 Replies
Will not start. Engine turns over fine. Have electric to lights, radio, everything but the fuel pump, coil and fuel gauge. Ignition switch and fuel pump check out okay. Checked fuses, okay. Vehicle has an add on after market remote start/security system, has been working fine for years.
View 1 Replies
I have a problem with my Durango whenever i drive my car it is fine and normal. When i get to where I am at and i try to start my car again it will just turn over like it wants to start but doesnt. I just recently started driving the car for about 4 days ago and it drove fine. Until yesterday i got to my shop and tried to start it.. it will just crank. I scanned it and it turned out i had a bad crankshaft sensor. I gone ahead and replace that and the car starts up fine. I drove it around town and then this morning drove it to work and when i tried to leave for lunch it did the same thing. It cranks but does not fire up. I scanned it.. and no codes. My dad was saying something like sometimes it has sparks going to the crank and sometimes it doesn't.
View 2 Replies
I have a 2005 Dodge Durango, 5.2 liter hemi engine, 135,000 miles. For the last three months the car has emitted a high-pitched whine when the engine starts, while the transmission shifts through the gears, and while the car is at speed. The tone remains the same as the car runs, but it seems liked to the engine revs as the transmission shifts. A very reputable mechanic has tried to find the source without success. He's run all the diagnostics, and used a stethoscope. He checked the alternator and the power steering pump and replaced two belt pulleys, but the whine is still there. He so far has not been able to locate the source. He says he's heard the same noise on a couple of other Dodges or Jeeps with the same engine. I'd like to know what's causing this whine and how to fix it.
View 8 Replies
Was running with a slight miss until reach 30 mph for about 5 days now this morning, turning over and over but won't start..checked 2 plug wires no spark to ground..how to fix and make start?
View 5 Replies
I have a 2001 saturn sl 2 and I noticed some oil around all the spark plugs. The engine seems to be loosing oil a little bit as well, about a quart a week. Its not buring it or leaking that I noticed.
View 2 Replies
I have a 2001 Hyundai Sante Fe that died on me while driving down my street. The engine sounded like it was loading up for about 1-2 seconds, then it died. It turns over but does not fire.
After a little troubleshooting, I have no spark in cylinders 1 and 4. I swapped the two coils thinking that I had a bad coil, but then the suspected bad coil created spark on the 2-3 cylinder side. So both coils work.
I towed the car to the shop and the mechanic after about 2 hours of billed labor, he is leaning toward a bad ecu. He said there also is no fuel metering from two of the fuel injectors. He checked the resistance on the injectors and said they are fine. He is thinking it is a control/command issue. The car has many other unrelated problems and I am not sure I want to spend too much more money on it.
I am skeptical about a bad ecu. Or sensors that may be causing my two cylinder no spark and alleged fuel problem?
View 14 Replies
