Ford - Explorer :: 2008 - Delay When Start After Truck Is Warmed Up / Hot
Aug 14, 2015
I'm having a slow start issue with my 2008 Explorer Sport trac. Recently it's received a brand new fuel pump, a new fuel pump driver, new spark plugs and ignition coils! And it still hasn't fixed the problem, what's happening is when I start the truck after its hot, there's somewhat of a delay. As if it's starving for fuel, however, in the mornings on its first start or after a shift at work it starts just fine on the first start which prompted me to now think I'm having vapor lock! Gas cap is brand new too. I had the fuel injectors tested and they all seem fine, I'm at a complete loss.
It's killing me and as one can imagine I have spent a lot in parts and at this point in my life I have had to pay for labor instead of my usual DIY because I recently had major back surgery due to being hit by a big rig in December of last and pushed into the rear of an F350 while I was at a complete stop and the rig was doing about 40 mph. Been suffering ever since with constant doc visits, surgeries and so one to correct the issues. I'm tired of shelling out money with no solution, I had a solution I thought but apparently I was wrong. I'm going to change all relays that I think may affect the area....
View 3 Replies
Advertisement
I have a 97 f150 with a 4.9..... I drove it less than a half a mile and shut it off. when I got back in it to start it up it wouldn't do anything like the battery was dead but all the electrical worked but it would not turn over. after about 4 hours when I returned, it started just fine. drove it straight home and shut it off and immediately tried to start it again and had the same issue. What the culprit may be ?
View 1 Replies
Twice in the past week our truck wouldn't start. The first time I sprayed starting fluid in the intake and it started. This morning I went to the Dr and when I got out it wouldn't start again and my can of starting fluid didn't squirt. I called my wife and had her bring another can but in the mean time I changed the fuel pump relay in the fuse box under the hood and it started reluctantly, it sputtered at first until I put some pedal to it. I don't think that is the problem. I got it home and checked the codes, there were none. I'd say fuel filter but it runs good at high speed. If there were no spark there would be a code so I assume it's fuel related. It's run perfectly since I acquired it last year.
View 3 Replies
I have a delay when I put my truck into gear. It only happens when I have turned the truck back on. It happens in forward as well as reverse. What is causing this? Syncros?
View 8 Replies
I have a 1999 ranger 3.0 4x4 automatic the truck has a delay when put into drive sometimes it slips at take off unless I force it to downshift and stay in first and from second to third gear it shifts very hard at around 3500 rpm would an oil and filter change. I do not have the cash for a new trans and I can't afford a new truck. I love my little ranger...
View 10 Replies
I am trying to understand why my truck will not accelerate until it has warmed up some...
View 5 Replies
Ok I am getting a (6R140) transmission behaviour every morning drive or later in the day after the transmission cools down. I am experiencing a 2-3 second delay of engagement when putting truck in Reverse. This happens EVERY time whether transmission is cold or warmed up. I am also having very hard/harsh shift fares going into 3rd gear and 5th gear with the 3rd gear being the worse of the two. Also experiencing these hard/harsh shift when downshifting as well.
I took the truck to my local dealer and I let it sit over night in their lot so they could experience it at its worst after sitting all night. They definitely recognized the issue. But since it wasn't throwing and codes. I find this an unacceptable answer.
I brought to their attention that this issue is well documented online and a lot are having success with performing TSB 11-7-10 (replacing solenoids) They looked it up and said my truck doesn't apply to TSB because of the build date. My window sticker and VIN # implies the truck was built 10-11-2010. Which from my understanding, does fall under the required TSB. None the less, I insisted that I know I'm out of warranty and I will just pay to have this TSB performed. They refused.
What should I do? I know everyday I run my truck with this issue it is decreasing the reliability of this transmission and it will most likely end with a full transmission replacement.
View 5 Replies
Ok, I replaced the head gaskets on this truck a couple years back and now I am having symptoms similar to the ones I was having then. I am not entirely convinced that this is what is wrong however.
Symptoms:
Truck was idling rough until it warmed up
Truck takes forever to warm up or simply does not warm up
If/when it warms up it operates at higher than normal temp/almost overheats(it hasn't overheated yet)
Heater blows very cold air
White smoke(has been cold outside so not sure if due to temp or coolant)
Overflow bubbled when I shut the truck off, but it has only happened once so far
I am kind of at a loss, but like I said am suspicious of the head gaskets.
View 8 Replies
The explorer has been having an issue starting after its warmed up. Starts perfectly fine when its cold. but sometimes when I drive, stop for 1-10 minutes, it takes a long time to get her to start up. Typically 30sec to 1 min of cranking. Doesn't seem to have any idle issues or issues running.
View 2 Replies
My wifes 2006 mountaineer V8 overheats. She says itll only do it sometimes after the truck has been warmed up. She will come top a stop and the temp will spike and she will get a warning light then it will go back to normal and be fine. When the temp spikes she hears a loud whooshing or whirling sound coming from the motor which I supposed is the fan? Could it be a bad thermostat or waterpump?
View 1 Replies
Just had my 2010 F150 in for a loud knocking noise when the truck has warmed up in drive and rpm up to about 800. I can't hear the noise when I disconnect the passenger side vtc selonoid. The Tech who worked on it has recommended replacing the motor. His troubleshooting on the ticket says he removed the coil from the number 4 cylinder and the noise he hears goes away. I just can't see that the motor is bad.
View 8 Replies
2003 with 2005 motor, auto trans. After truck is warmed up and been driven a while I get a vibration/nice when stopped. Sometimes the Vibration changes with the brake peddle application. Is there a ps hose that can go bad internally on these? Anything else to look for. It's easy to hear/feel in the cab but can't hear it under the hood. Changed the ps fluid with no change.
View 14 Replies
Just got an 04 f150 STX 4.6L Regular cab.
Drove fine for a few months (she's a little rough, but she does the trick).
The other day, I went out to go to work, truck would start and run, won't come out of park. Both turn signal indicators on the dash are illuminated, turn signals, flashers, radio and Climate controls do not work.
Currently driving with the emergency shifter release pulled out and zip tied open. First thought was interlock switch, but I'm not sure if that would affect everything else.
This happened once before, and I pulled all the taillights and checked all fuses, then it just seemed to work again after flipping the rheostat for the interior/dash lights. didn't work this time around.
Dash is all torn apart - where to start looking?
View 14 Replies
I just went out to move my truck to take out garbage and it cranks but doesn't start. It is 4.6L 4WD. I sprayed ether in intake no change. Checked all fuses all good. It has been raining pretty hard the last 3 days and it has been sitting in rain all 3 days. I checked for codes with a simple code scanner no codes. But the code scanner I used is not able to do KOEO or KOER tests. I know it needs new plugs but it has never sputtered or died on me. Has slight misfire but not engine stopping. I havnt had any check engine lights or problems before.
View 3 Replies
I've been noticing over the past couple years that sometimes when I accelerate, there's a slight delay between the time I press my foot down on the pedal and when acceleration actually happens. From reading other threads it would seem that the most common fix is to re-flash the ECU. I bought a DiabloSport Predator tuner along with a CAI a while back to improve performance/gas mileage and I was wondering if there's a way I can use the tuner to re-flash.
If not, do most ford repair shops already carry these? I don't want to buy a flash programmer. Also, if the shop does carry this type of an item, what is the average cost to get it re-flashed?
I own an '04 F150 XLT 5.4l.
View 1 Replies
I bought my 2005 f150 three years ago and the auto headlights never worked. I have just turned them on manually. Couple weeks ago they started to delay coming on and now they do not work at all. All other lights work including fog lights.
View 1 Replies
I have an automatic 2004 f150 fx4 with a 5.4 engine. I just bought the truck and noticed the other day that when I shift into reverse, there is a 1-2 second delay. Sometimes it will shift quicker than other times. Drive seems to be a little more swift I think. Everything seems to run smooth and the shifting is very smoot other than the delay. Is this normal or what could be some of the causes. The previous owner has the ATF changed this pst summer and it looks and smells fine other than maybe having to much fluid.
View 2 Replies
I've got an 04' F150 and the ONLY problem I have with it is a ridiculously sluggish throttle. I bought the Superchips Tuner in hopes of eliminating this, but the delay in the throttle is still there (power is much better however). When I talk delay, I am talking hitting the gas and probably a realistic .5-1 sec delay. It is quite annoying to say the least.
My question...is there something that I can do myself to improve the throttle response? I drove an older 150..probably an 02 or 03 and it felt sooooo much more powerful just do to the throttle. I am even willing to ditch the Superchips if the Ford re-tune would do a better job.
View 14 Replies
I just got this truck about a month ago now and today it started fine and when I got home from work, I ate dinner and then went out and it started fine and once i got home i let it sit for an hour and then went to do more errand and it wouldn't start. I checked fuses and what not it all looks ok. I got the truck to start by jumping the wires on the starter. What might be causing the truck to do this? as i say today is the first time this has happened?
View 8 Replies
My friend had his 2008 F150 Limited washed and they apparently decided to pressure wash the engine.
Now the check engine light is on, and it runs like crap. At least yesterday, today it won't even start.
What is broken? The codes said something about the throttle body?
View 5 Replies
The other day my truck stalled out and wouldn't start so I had it towed to the shop, the shop tested the fuel pump but couldn't find anything and it fired up and ran fine for them. It ran fine for a day and now is running extremely rich. The only code it's throwing is P0452 which is for the evap system. I spent awhile searching but couldn't find any answer on it.
I couldn't find any loose connections in the harness or on top of the fuel tank, I had the classic FDPM issues before so I replaced that. I'm beyond frustrated with this hulk seems like once a month it wants to quit working.
View 3 Replies
