Ford Transmission :: 2001 - Reverse Started To Fail?
Jan 6, 2017
Had this thing rebuilt less than 8k by a reputable local trans builder and the reverse started to fail on me told the guy the problem and said everything is "normal". Drove it and the thing started to act up slamed out of OD and the light started to blink. Took it to the guy to get it checked and said most likely the tranny is toast the fluid does smell burnt.
Then he told me that I had two codes and that they were the cause of the tranny to fail, the codes were P1105, P1106 and that the voltage going to the solenoids was low roughly at 8.6 volts... Can the alternators have anything to do with tranny messing up? I took the to be tested and both alt are good I have a constant supply of 14.4 volts from the alternators. Can this be the pcm taking a dump?
Forgot to mention that this is a 2001 f250 platinum Edition 7.3 power stroke.
View 7 Replies
Advertisement
2001 Accent, 1.5L Automatic with OD, 263,000 km
Transmission goes into Fail Safe Mode but the CEL does not light up and code reader shows no codes. Shifts fine in town,1-2-3-4...4-3-2-1, but on highway when going up inclines (steep), transmission downshifts from Overdrive into 3rd,as i press the accelerator it will downshift into 2nd (as normal), until i reach the top of the incline (3500-4000 rpm) but then as the car levels out on the highway, it will shift back and forth between overdrive and 3rd, (jerky shifting) then finally goes into Fail safe mode, 3000 rpm at 80-90 km/h. Once I shut the car off for a few minutes, the transmission is fine and shifts normally. Fluid levels are good. Why the CEL is not giving code?
View 1 Replies
I have a 89 f-150 xlt with what i believe is the m5od (4 speed with O.D) transmission and the 5.0 motor, the trans has been whining since I've owned the truck and it started popping out of reverse on me a couple months ago, now i have to slam it into gear to make it go anywhere even when I am going down the road! The clutch is fine but the trans is hanging up, anyways i have a granny gear transmission a buddy of mine gave me out of an 85 f150 that had the inline 6 if i take the bell housing off of my transmission can i put the internal slave cylinder on that transmission? Will it work or will i have to find a way to put an external slave cylinder on it?
View 9 Replies
I have 2001 ford taurus the transmission went out on me -as i started from stop light the transmission sounded like it was going into gear all the way I let off the gas and it went into gear this happened a few more times until i got on interstate and when i interstate no problems at all with transmission then I pulled off to go home and mre stop lights it acted same way then after a few more lights i gave it the gas from stop light and no forward gears i do have reverse is a sensor bad ...
View 15 Replies
2001 7.3L I purchased used with 200K on it. Trans hesitates going from 1st to reverse and reverse to 1st. It seems more pronounced going from 1st to reverse. Fluid is clean.
View 2 Replies
My 2003 Santa Fe makes a grumbling noise when first started, and put into drive or reverse. The noise seems to be coming from the passenger side of the engine compartment. The noise disappears when the drive train has warmed up.
View 4 Replies
my parents have a f350 which now has no reverse. it has a reman sticker on it, 230k on the truck but no idea on mileage on the tranny. shifts 1st through 4th fine, no slip. Tc lockup works just fine. No codes found with my solus scanner. When shifted in reverse it will move back about 2 ft if revved above 2k and then nothing. Am I looking a trans rebuild or is there something I can check and repair with in it the truck?
View 4 Replies
I have a 2001 F250 V10,
So the truck drove fine yesterday had zero issues... I used my auto start as I do every morning in this cold weather, get into the truck and shift from park to drive and its like it does nothing. I can free rev in N,D,1,2. Reverse works great.
I tried switching from 4wd to 2wd, no change. Reverse works just fine. No noises, codes or anything, just doesn't want to engage...
I am assuming I have a 4R100. Could something electrical cause this? I am thinking its mechanical, but hoping someone has ran into this before.
Literally no way I would have known the trans was going bad... It's always worked fine. Tranny fluid is full, I tried unplugging the battery waiting and plugging back in, no dice.
View 11 Replies
I have a question regarding my mk4 jetta. I plan on swapping my tiptronic transmission, which is beginning to fail (at least that's what I'm assuming the really hard upshift is indicating), to a standard manual transmission. The previous owner had it stage1+ tuned.
View 2 Replies
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 Replies
I just did a motor swap on a 2003 with 3.5 auto tranny and awd. engine runs great and every thing is running fine. Only problem is that the trans will not create any power. With no drive shafts on it still wont move the splines. With that said the trans was driving/running great b4 the swap.
View 2 Replies
My grandma had purchased an almost brand new B6 Passat with the 4-motion VR6 all leather interior with about 8k on the odometer. Recently she has had some problems with it and has asked me what is going on, My dad has an Audi Allroad, my mom has a 01 A4 event and I have a 04 GLI so we know some stuff about the cars but these problems are eluding me and I was going to look for some counseling. First, her front tires are making this horrible sound, she says it sounds like a Mack truck and it gets worse as you go faster. I'm thinking its the tires but why would it be like that only after 8k? The second problem is her transmission, she has had the transmission fail to engage into gear 3 times, where it takes about 2-10 seconds before it engages. Now the car has about 10k on it. [URL]....
View 11 Replies
2000 F150 Lariat, XC, 2WD, 5.4L, 4R70W
I don't know if this all started right after I got back from towing a 3500# lathe + 2000# trailer back from Texas a couple weeks ago or if there might have been some slight symptoms before. I do know that this really got bad a couple days ago and I haven't driven the truck since then.
So, here's what is happening. I noticed a few days before that when I would back out of a parking space, the truck didn't seem to go right into reverse. It was as if it was in neutral, but as I was reaching to jiggle the gearshift lever, it would engage and I could back out just fine. All forward gears, and shifting, have been fine all along, including lockup. I kind of wondered if the shift linkage had somehow moved and was on the edge of being in the right spot, so I was going to have a look at it one evening soon. Then a couple days ago, I went to back out of a parking spot at work and it wouldn't go anywhere.
Just acted like it was in neutral. Put it in drive and it engaged just fine, then back to reverse and nothing for a few moments before it finally engaged. Then, as I was backing up, it acted like you might expect a limited slip that was not slipping to behave. But, that was right before I put it in drive and went home. After I got home, I tried it out some more and found that in reverse, it just wouldn't go anywhere unless the truck rolled a little bit. I don't know if the rolling really had anything to do with it or not, but the driveway is on a slight incline, so it happened, and then the transmission would engage. But, when it did start to back up, even straight, at first it acted like it was under a load, then when it started to move, it bucked really badly. Put it back in drive and all seems fine.
There are no codes set. Trans fluid is full, and doesn't smell or look bad. I've searched for reverse shudder, and other stuff, and there are threads about the TC, about no reverse at all, and a bunch of other stuff, but nothing like this that I found.
View 4 Replies
I have a 2001 pontiac grand am se 4cyl with an automatic transmission and I've been having issues with my transmission, about a month ago the transmission started shifting hard then just went out so i took it to a transmission repair shop and the tech said that it was the pulling clutches and i told him to completely rebuilt the transmission including new electronics and torque converter and he did i got it back and it drove fine for that day then stared doing the same thing my transmission slams into gears and I don't know what the problem is sometimes ill be going down the road and the transmission slams and then the trac light comes on for a little bit then goes back out??? also some days i can drive it a mile or 2 before it starts slamming into gear.. what this could be causing it to slam i would think it couldn't poss be the transmission as everything has been replaced? could something else be causing it to slam into gear..
View 7 Replies
I have an '01 Dodge Ram 1500 that will not go into reverse while the truck is running. The hydraulic clutch and transmission fluid levels are good.
View 1 Replies
I'm having trouble with the automatic transmission in my 04' Elantra, it acted like the speed sensor was failing, but later the same day it lost all gears, forward and reverse. after turning the car off and sitting a while I started it back up and had gears again, but the trany is making noise. Fluid level is ok.
View 3 Replies
I recently bought a 2001 Sante Fe 4X4, (my first Hyundai), that has transmission issues. It has about 135,000 miles on it. It will start easily, and go into Reverse just fine, but would not move in any forward gears. It would occasionally shudder a bit when put in 'drive', but only move forward a few inches. Recently, my mechanic backed it around, then decided to try it in forward again. This time it went forward a couple hundred feet, then quit moving forward. Do I need a new transmission, and if so, what vehicles use this same transmission? Or is there a sensor or valve that could be defective?
View 5 Replies
2001 VW Jetta 1.8t automatic.
Transmission has a hard time going into 1st and reverse. Also some times hits hard going into third. I have a CEL for a vehicle speed sensor? Was wondering if it's not the VSS but maybe one of the other tranny sensors?
Separate question. Same car has a rough idle issue. Occasionally stalls but intermittently runs normal always has a low idle around 600 rpm. I have a code for an injector on cylinder three.
VSS code : P0725 - engine speed sensor circuit malfunction
Injector code : P0203 - injector circuit open cyl 3
View 4 Replies
No codes, transmission makes a slight grinding noise when putting it into reverse only. Has a slight bump from 1st to 2nd. I flushed 16 quarts of the sp3 through it. Been researching and see a lot of talk about the output and input sensors. Not my car but my sisters. Needs axles, timing belt water pump, ps return hose, plus have champions in there and old ass hyundai wires.... thing does idle rough, motor mounts are new.
View 1 Replies
2002 Santa Fe, 2.7 AWD
The transmission has started going into limp mode and causing the check engine light to come on.
The codes given are p0750 and.... I think p0751, for shift solenoids C and D. There is also the generic Transmission Control Module code.
Limp mode only occurs at higher speeds although shifting feels a little rough at times in lower speeds.
If operated in manual mode the vehicle can be driven normally at all speeds without going into limp mode.
Fluid levels are fine.
With limp mode occurring in automatic but not occurring in manual mode, is it more reasonable to believe the solenoids are malfunctioning or the control module itself? I'm inclined to replace the solenoids but find it odd that the vehicle operates normally in manual. Also, can the solenoids be replaced without removing the transmission? It looks like I could get the pan off but am unsure if there is room to get the work done once it is removed.
View 2 Replies
I have a 2001 Accent GL 1.6L Automatic.
Yesterday it started acting up on the freeway. I was driving about 50 during traffic hour when it started revving. I got off the freeway and moved to 35mph on surface streets, the revving continued at lower speeds but much worse (4-5k rpms going 10-15mpg). Doesn't seem to do it in idle or park. If i shut the car off it'll drive fine for a while then start acting up but when I was driving, after awhile, it did return to normal.
What could cause the problem? TPS? Transmission? Sensor of some sort?
View 5 Replies
